Pioneer SR9 Reverberation Amplifier Display issue

Moderator: interruptor

Post Reply
mystic
Posts: 1
Joined: Mon Jun 14, 2021 4:15 pm

Pioneer SR9 Reverberation Amplifier Display issue

Post by mystic » Mon Jun 14, 2021 4:27 pm

Hello guys, I am new here seeking some answers for this issue I have run into. I have 2 models, SR303 and SR9.

On my DJ set I run my pc through the SR303 reverb then back to line In on my mixer with no issues. With this SR9, I connect it's IN and OUT to the TAPE Monitor on the Kenwood Receiver.

When I play music from my PC the SR9's display works only for a short while then doesn't display anymore not even after I crank the volume up but when playing through FM no issues and even at low volume. I am wondering if the SR9 needs to have a strong signal in order for the display to show all the time?

FM gives almost double the output than my pc so this is making me wonder. On my DJ set I run my pc through the SR303 reverb then back to line In on my mixer with no issues, any thoughts please?

Post Reply